ALLIED Vision Technologies Pike F-1600 - Manual (Page 226)

Controlling image capture
PIKE Technical Manual V5.1.2
226
Enabling this feature turns the camera into a special mode. This mode can be
used to set up a bunch of parameter sets for up to MaxLength consecutive
images.
Setup mode (new for 3.x)
The SetupMode flag allows you to set up a sequence while capturing images.
Using this flag you get a visual feedback of the settings.
Set SetupMode flag when setting up the sequence and reset the flag before
using the sequence.
Sequence step mode (new for 3.x)
The SeqMode field selects the signal source for stepping the sequence one
parameter set further.
0xF1000228 SEQUENCE_STEP Presence_Inq [0] Indicates presence of this feature
(read only)
--- [1..4] Reserved
PerformStep [5] Sequence is stepped one item for-
ward
PerformReset [6] Reset the sequence to start position
--- [7..23] Reserved
SeqPosition [24..31] Get the current sequence position
Note

The sequence mode of the Pike 3.x series firmware behaves
slightly different than the sequence mode of e.g. the Marlin
series and implements some new controlling features. You may
use a sequence with internal or external trigger and with the
Deferred Transport feature.
Register Name Field Bit Description
Table 80: Advanced register: Sequence mode