Io_inp_ctrl 1-2, Table 26: input routing – ALLIED Vision Technologies Pike F-1600 User Manual
Page 118
Camera interfaces
PIKE Technical Manual V5.1.2
118
IO_INP_CTRL 1-2
The Polarity flag determines whether the input is low active (0) or high active
(1). The input mode can be seen in the following table. The PinState flag is
used to query the current status of the input.
The PinState bit reads the inverting optocoupler status after an internal nega-
tion. See
Figure 61: Input block diagram
This means that an open input sets the PinState bit to 0. (This is different to AVT
Marlin/Dolphin/Oscar, where an open input sets PinState bit to 1.)
ID
Mode
Default
0x00
Off
0x01
Reserved
0x02
Trigger input
Input 1
0x03
Reserved
0x06
Sequence Step
0x07
Sequence Reset
0x08..0x1F
Reserved
Table 26: Input routing
Note
If you set more than 1 input to function as a trigger input, all
trigger inputs are ANDed.