ALLIED Vision Technologies Pike F-1600 - Manual (Page 219)

Controlling image capture
PIKE Technical Manual V5.1.2
219
One-shot command on the bus to start of
exposure
The following sections describe the time response of the camera using a single
frame (one-shot) command. As set out in the IIDC specification, this is a soft-
ware command that causes the camera to record and transmit a single frame.
The following values apply only when the camera is idle and ready for use. Full
resolution must also be set.
Microcontroller sync is an internal signal. It is generated by the microcontroller
to initiate a trigger. This can either be a direct trigger or a release for ExSync if
the camera is externally triggered.
Feature Value
One-shot  microcontroller sync
150 μs (processing time in the
microcontroller)
μC-Sync/ExSync  integration start 8 μs
Table 77: Values for one-shot