ALLIED Vision Technologies Pike F-1600 - Manual (Page 116)

Camera interfaces
PIKE Technical Manual V5.1.2
116
Control and video data signals
The inputs and outputs of the camera can be configured by software. The differ-
ent modes are described below.
Inputs
The optocoupler inverts all input signals. Inversion of the signal is controlled
via the IO_INP_CTRL1..2 register (see
Table 25: Advanced register: Input con-
trol on page 117).
Triggers
All inputs configured as triggers are linked by AND. If several inputs are being
used as triggers, a high signal must be present on all inputs in order to generate
a trigger signal. Each signal can be inverted. The camera must be set to external
triggering to trigger image capture by the trigger signal.
Note

For a general description of the inputs and warnings see the
Hardware Installation Guide, Chapter PIKE input descrip-
tion.
Figure 61: Input block diagram
Input
Polarity
selectable
via software
Input state
Opto-
Coupler
Input signal