ALLIED Vision Technologies Pike F-1600 - Manual (Page 167)

Description of the data path
PIKE Technical Manual V5.1.2
167
• Activate/Deactivate defect pixel correction (factory default setting: acti-
vated on startup of AVT SmartView)
• Save/load of AVT-own defect pixel map for external use
• Displaying current defect pixels of the camera
• Add/remove defect pixels
With an upload to and download from the camera you can manipulate the defect
data stored in the camera. Additionally you can activate and deactivate defect
pixel correction entirely.
Section Check box / button/ combo box/
list / slider Description
Defect pixel correction  Defect pixel correction on Activate check box for applying defect pixel
correction.
Note: This check box is not activated on
SmartView startup in general.
Activation of DPC is factory default for the
camera. Setting of the check box is only
dependant on current setting in the camera,
but not on startup of SmartView.
Edit sensor defects Loads current defect pixel data into the cam-
era and opens the Defect pixel editor in AVT
SmartView.
Table 51: SmartView Edit settings: Adv 4 tab (Defect pixel correction)