Xerox 7675 - Manual (Page 195)

193
12. Select [NetWare] for protocol.
13. Enter the server name where the fax repository is located, in [Server Name].
14. Enter the server volume in [Server Volume].
15. Enter the context and tree (NetWare 4.x, 5.x, 6.x IPX only.) for the repository in [NDS Context] and
[NDS Tree]. For NDS enter a name context. For bindery and bindery emulation, leave these fields
blank.
16. Enter the path to the fax repository in [Document Path].
17. Enter the [Login Name] and [Password] to access the scan filing location. Also, select System to have
the system log into the server, or Authenticated User to have your Authentication Server determine
access.
18. Click [Apply] to accept the changes.
Configure General Settings
19. Click Defaults in the left hand pane.
20. To print a Confirmation Sheet after every Server Fax job select Edit in the General section, then select
On from the drop down menu. The Confirmation Sheet specifies the success or failure of the Server
Fax job. If the fax is successful the location of the document on the fax server is also specified.
21. Check the [User Name] and [Domain] boxes if you want these to appear on the Job Log. The Job Log
is filed in the fax repository with the fax job.
22. Click [Apply].
Go to the FAX server
23. Configure the fax server so that it is able to monitor the fax repository for documents. Refer to the
manufacturer's documentation provided with your fax server to complete this task.
At the Machine
24. Select the [Server Fax] button from the touch screen, then touch [OK].
25. Enter a valid fax number. Press [Add], then [Close].
26. Load a document in the document handler and press the green start button.
27. Verify that your fax is received at the specified fax machine.
You have completed the steps to enable Server Fax.