HEIDENHAIN ND 287 User Manual - Manual (Page 86)

86
II Installation, specifications
II – 2 Installation Set
u
p
 Press the 7/8 soft key to set the DATA BITS field to 7 or 8.
 Press the 1/2 soft key to set the STOP BITS field to 1 or 2:
 The PARITY field can be set to NONE, EVEN or ODD using the soft
keys provided.

OUTPUT TAIL is the number of carriage returns that will be sent at
the end of the transmission. The output tail is initially 0 and can be
set to a positive integer value between 0 and 99 by using the
numerical keys.
For information about the cable connection, pin assignment, data
input/output and external operation, see "Data interface" on page 100.
The serial port settings will be retained on a power cycle.
Fig. II.44 Data interface: Parameter input
Fig. II.45 Data interface: Parameter input
There is no parameter to enable or disable the serial ports.
Data will only be sent to the serial port if the external
device is ready
.
Data is transferred in the following sequence: Start bit,
data bits, parity bit, stop bits.