Key commands, Ii – 5 d a ta int e rf ace – HEIDENHAIN ND 287 User Manual User Manual
Page 106

106
II Installation, specifications
II – 5 D
a
ta int
e
rf
ace
External operation via RS-232-C/V.24 or USB
interface
Key commands
You can operate the ND 287 remotely over the RS-232-C/V.24 (X31) or
USB (UART, X32) data interface using an external device. The
following key commands are available:
Format
Key is pressed
Output of screen contents
Execute function
Execute special function
Sequence of commands
Function
Key '0'
Key '1'
Key '2'
Key '3'
Key '4'
Key '5'
Key '6'
Key '7'
Key '8'
Key '9'
CLEAR key
Key '–'
Key '.'
Navigation key
Key 'ENTER'
Key 'Cursor Up'
Key 'Cursor Down'
Key 'Soft key 1' (left)
Key 'Soft key 2'
Key 'Soft key 3'
Key 'Soft key 4' (right)