Introduction, Software version, Symbols within notes – HEIDENHAIN ND 287 User Manual User Manual
Page 5: Fonts, Intr oduction introduction

ND 287
5
Intr
oduction
Introduction
Software version
The software version is shown on the power-up screen of the ND 287.
Symbols within notes
Every note is marked with a symbol on the left indicating to the
operator the type and/or potential severity of the note.
Fonts
The chart below shows how the different variables (soft keys, hard
keys, forms and form fields) are represented within the text of this
manual:
Soft keys – SETUP soft key
Hard keys – ENTER hard key
Menus and forms – UNITS OF MEASURE form
Parameters and input fields – ANGULAR field
Data in fields - ON, OFF
This manual describes the functions that are available in
the ND 287 and the installation of the units.
General information
e. g. on the behavior of the ND 287.
Refer to accompanying documents
e.g. when a special tool is required for a function.
Danger to the operator, workpiece or internal
components
e.g. danger of collision
Electrical hazard
e. g. danger of electrical shock when opening a housing.
The ND 287 must be prepared by a qualified and
authorized technician to perform this function.