beautypg.com

Unit of measure, I – 4 j o b set u p – HEIDENHAIN ND 287 User Manual User Manual

Page 34

background image

34

I Working with the ND 287 position display unit

I – 4 J

o

b Set

u

p

Unit of measure

The UNITS OF MEASURE form is used to specify the preferred display

units and formats for linear and angular measurements. The ND 287

powers up with these settings in effect.
In the LINEAR field, define the unit of measure for linear

measurement:

In the JOB SETUP menu, select UNITS and press the ENTER key to

open the form.

Use the MM/INCH soft key to switch between MM and INCHES.

This can be performed in either Actual Value or Distance-To-Go

mode.

In the ANGULAR field, define the format and input mode for angles.

Press the ANGLE soft key to switch between DECIMAL DEGREES,

RADIANS and DMS (degrees/minutes/seconds).

The defined unit of measure is shown in the status bar on the standard

screen.

Fig. I.25 Unit of measure

This manual is related to the following products: