Ii – 2 installation setup, Installation setup menu – HEIDENHAIN ND 287 User Manual User Manual
Page 70

70
II Installation, specifications
II – 2 Installation Set
u
p
II – 2 Installation Setup
INSTALLATION SETUP menu
The ND 287 offers two categories for setting up operating parameters:
JOB SETUP and INSTALLATION SETUP.
The JOB SETUP parameters are used to accommodate specific
machining requirements for each job, see "Job Setup" on page 30.
The INSTALLATION SETUP menu is used to establish encoder,
display and communication parameters.
To call the INSTALLATION SETUP menu:
Begin by pressing the SETUP soft key. This opens the JOB SETUP
menu.
Press the INSTALLATION SETUP soft key.
Use the numeric keys to enter the correct passcode (95148) and
then press ENTER.
INSTALLATION SETUP parameters are established during the initial
installation and, most likely, will not often change. For this reason, the
INSTALLATION SETUP parameters are protected by a passcode.
When in the INSTALLATION SETUP menu, the following soft keys will
be available (see Fig. II.7):
JOB SETUP
Press to begin accessing the JOB SETUP parameters (see "Job
IMPORT/EXPORT
Press this soft key to call the IMPORT or EXPORT soft keys for
transmitting the operating parameters (see "Serial data transfer with
the Import or Export function" on page 101).
HELP
This soft key will open on-line help.
Press the NAVIGATION key to move through the pages of menu
parameters. To view and change menu parameters, use the UP/
DOWN arrow key to highlight the parameter of interest and press the
ENTER key.
On the following pages you will find more information on the menu
parameters.
Fig. II.7
INSTALLATION SETUP menu
Once you enter the passcode, it will not have to be
entered again until you cycle power.