beautypg.com

Error compensation, Ii – 2 installation set u p – HEIDENHAIN ND 287 User Manual User Manual

Page 79

background image

ND 287

79

II – 2 Installation Set

u

p

Error compensation

The distance a cutting tool travels, measured by an encoder, can in

certain cases, differ from the actual tool travel. This error can occur

due to ball screw pitch error or deflection and tilting of axes.
This error can either be linear or non-linear. You can determine these

errors with a reference measurement system, e.g. the VM 101 from

HEIDENHAIN. From an analysis of the error it can be determined

which form of compensation is required (linear or non-linear).
The ND 287 can compensate these errors. Each axis can be

programmed separately with the appropriate compensation.
The ND can also compensate errors caused by temperature
influences

. A linear encoder must be connected to input X1, and an

analog module (option) with a temperature sensor must be connected

to input X2.

Only non-linear error compensation is available when

using rotary encoders.

This manual is related to the following products: