beautypg.com

Starting and stopping a series of measurements – HEIDENHAIN ND 287 User Manual User Manual

Page 48

background image

48

I Working with the ND 287 position display unit

I – 5 Ser

ies of measur

ements and statistical

pr

ocess

c

ontr

ol

Starting and stopping a series of measurements

Select the first soft-key page of the standard screen.

Press the START MEAS. SERIES soft key to start a series of

measurements. If the START SPC soft key is displayed on the

screen, press the SPC [MEAS. SERIES] soft key to open the SPC

menu, and then press the SPC [MEAS. SERIES] soft key to switch

to the SERIES OF MEASUREMENTS mode (see "Switching

between series of measurements and SPC mode" on page 42). If

the ND 287 is configured for two axes and the display mode X1:X2

is not active, then the ND records the values for both axes

simultaneously after the series of measurements has been started.

The ND can store up to 10000 values per axis. The measured-value

counter is shown on the left side of the message line. It shows the

number of the current value being measured and the total number

of values to be measured, e.g. 0/50.

If required, you can switch the display mode during the series of

measurements by pressing the SELECT DISPLAY soft key (see

"Defining the display for a series of measurements" on page 46). The

currently active display mode is highlighted in the status display:

MIN, ACTL, MAX or DIFF.

You can stop the current series of measurements at any time by

pressing the STOP MEAS. SERIES soft key. When the defined

number of measured values has been reached, the ND stops the

series of measurements automatically.

The DYNAMIC RESET soft key appears only if you use the ENTER

key or an external signal for saving and if you have selected the MIN,

MAX or DIFF recording mode. If you press this soft key, the MIN,

MAX and DIFF values are reset to zero.

All parameters required for a series of measurements and the

possibility of analyzing a previously recorded series of measurements

are provided by the SERIES OF MEASUREMENTS menu.

Fig. I.47 Standard screen with soft-key page 1

Fig. I.48 Series of measurements has been started

When a series of measurements is started, the MIN/

MAX/DIFF memory is automatically reset, and the

measured values of the last recorded series of

measurements are deleted.

A new series of measurements cannot be started until

the current series of measurements has been

concluded.

This manual is related to the following products: