beautypg.com

Setting up spc, Samples – HEIDENHAIN ND 287 User Manual User Manual

Page 52

background image

52

I Working with the ND 287 position display unit

I – 5 Ser

ies of measur

ements and statistical

pr

ocess

c

ontr

ol

Setting up SPC

Call the SPC SETUP submenu to define the SPC parameters:

Call the SPC menu.

Select SPC SETUP. This opens the SPC SETUP submenu. The

following parameters for setting up SPC are available:

SAMPLES

TOLERANCES

CONTROL LIMITS

STATISTICAL DISTRIBUTION

MEASURED VALUE RECORDING

In the following sections you will find more detailed information on the

menu parameters.

Samples

To call the SAMPLES form:

In the SPC SETUP submenu, select SAMPLES and press the

ENTER key to open the form.

Use the numeric keys to enter the desired value in the NUMBER OF

SAMPLES field, and press the ENTER key to confirm. A minimum

of two and a maximum of 100 samples are allowed.

Use the numeric keys to enter the number of measured values per

sample in the DATA PER SAMPLE field. Press the ENTER key to

confirm your entry. A minimum of three and a maximum of ten

measured values per sample are allowed.

If you edit the values entered, the ND displays a warning. In order
to save the changes, the ND must clear the data stored in the
FIFO memory.

Press the ENTER key to confirm, or press the C key

to cancel.

Fig. I.56 SPC SETUP submenu

In the sample parameters, you define the total number

of measured values for statistical process control

If you edit the values entered, the ND displays a
warning

. In order to save the changes, the ND must

clear the data stored in the FIFO memory.

Press the

ENTER key to confirm, or press the C key to cancel.

Fig. I.57 Samples

This manual is related to the following products: