HEIDENHAIN ND 287 User Manual - Manual (Page 71)

ND 287
71
II – 2 Installation Set
u
p
Setting up the encoder
In the ENCODER SETUP form you configure the ND 287 for the
connected encoder:
 The cursor will default to the ENCODER SETUP field upon opening
INSTALLATION SETUP. Press the ENTER key to confirm your
selection.

If you have configured the ND for two axes in the APPLICATION
field under COUNTER SETTINGS, a list of the possible encoder
inputs, labelled INPUT X1 and X2, appears.

Scroll to the input you want to configure and press ENTER.
 The cursor will be in the ENCODER TYPE field. Select the encoder
type by pressing the TYPE soft key:
 LINEAR: Linear encoder
 ROTARY: Rotary encoder
 COMPENSATION: If an analog module (option) with a
temperature sensor is connected to input X2, and a linear encoder
to input X1, the COMPENSATION parameter is available for
defining temperature-dependent axis-error compensation.
 SENSOR: For inputs with analog module (option) and connected
analog sensor
 Press the ENTER key to confirm your selection.

The ND automatically enters the measurement signal received in
the ENCODER SIGNAL field: NO SIGNAL, 1 VPP, 11 µApp,
EnDat 2.1, EnDat 2.2 or ANALOG.
Fig. II.8 Encoder setup form
Fig. II.9 Encoder type