Ii – 8 specifications f o r – HEIDENHAIN ND 287 User Manual User Manual
Page 138

138
II Installation, specifications
II – 8 Specifications f
o
r
Functions
Multilingual user guidance
REF reference-mark evaluation for distance-coded or single reference marks
Display for lengths, angles, or optionally for other measured values from analog
sensors
Distance-To-Go or Actual Value operating mode
Two datums
Scaling factor
Stopwatch
Reset or Preset function, also through external signal
Linear or non-linear error compensation for axis-error compensation
Trigger signals
Sorting and tolerance checking function with capacity for saving the
tolerances of 10 parts
Series of measurements:
Sorting
measured values and finding the Minimum, Maximum, Sum,
Difference, the traversing speed
or a definable coupled position value.
Displaying the sorting results in order to intervene, if necessary.
Memory capacity for series of measurements: Up to 10 000 measured
values per axis.
Analysis of series of measurements: Arithmetical mean value, standard
deviation
, graphical representation of all measured values with minimum,
maximum and mean value of the series of measurements.
Measured-value acquisition by external signal or selectable sampling
interval
, or by pressing the ENTER key.
Statistical Process Control (SPC)
:
Calculation of arithmetical mean value, standard deviation and range.
Displaying graphs or histograms with symmetrical or asymmetrical
density function
.
Process capability indices
c
p
and c
pk
, quality control charts for mean
value, standard deviation and range.
Measured-value acquisition by external signal or by pressing the ENTER
key.
FIFO memory capacity: Up to 1000 measured values
Diagnostics function
for testing the encoder, the keyboard, the screen, the
supply voltage and the switching inputs/outputs
Data transfer
of measured values and compensation values, configuration
parameters or software downloads via a serial interface
Integrated help system
Error compensation
Linear axes: Linear and non-linear (up to 200 compensation points)
Rotary axes: Non-linear (180 fixed compensation points spaced at 2°)
Axis-error compensation with temperature sensor
Temperature compensation using a reference part
Specifications