HEIDENHAIN ND 287 User Manual - Manual (Page 44)

44
I Working with the ND 287 position display unit
I – 5 Ser
ies of measur
ements and statistical
pr
ocess
c
ontr
ol Setting up a series of measurements
To define the parameters of the series of measurements:
 Call the SERIES OF MEASUREMENTS menu.

Select MEAS. SERIES SETUP.
 In the RECORD MEAS. VALUES field, activate or deactivate
measured-value recording for a series of measurements.
 In the RECORD field, select the trigger for recording the measured
values of a series of measurements. Press the RECORD soft key to
select one of the following possibilities:
 Sampling interval
 External signal at connection X41 (pin 22 or 23)
 ENTER key

Press the DOWN arrow key or the NAVIGATION key to display
further parameters.
If you have selected EXTERNAL SIGNAL or ENTER key, another
parameter needs to be defined:
 In the NO. MEAS. VALUES field, you enter the number of measured
values for the series of measurements. If you enter the value zero,
the ND deactivates the RECORD MEASURED VALUES function.
Fig. I.39 Setting up a series of measurements
Fig. I.40 Setting up a series of measurements
The ND 287 can store a maximum of 10000 measured
values per axis. The measured values recorded in a series
of measurements will only be retained in memory until
power is switched off.