beautypg.com

Setting the display modes of the axes, Formula for coupled position, Ii – 2 installation set u p – HEIDENHAIN ND 287 User Manual User Manual

Page 78

background image

78

II Installation, specifications

II – 2 Installation Set

u

p

Setting the display modes of the axes

The DISPLAY MODE soft key enables you to scroll through the

available display modes.

Press the SOFTKEY X1/X2 soft key to change the state of the

respective display mode from VISIBLE to HIDDEN, and vice versa.

In the HIDDEN state the respective display mode can no longer be

set with SOFTKEY X1 [X2] on the standard screen.

Press the ENTER key to confirm your settings, or press the C key to

cancel.

Formula for coupled position
In this form, you can enter a formula for coupling the two axes. The

following mathematical operations, symbols and variables are

available:

Basic arithmetic: Addition, subtraction, multiplication and division

Parentheses

Trigonometric functions: Sine, cosine, tangent, arc sine, arc cosine

and arc tangent

Circle constant pi

Axis variables X1 and X2

Enter the desired formula.

If you want to delete a character you have entered, press the DOWN

arrow key.

After you have confirmed your entries by pressing ENTER, the

ND 287 checks the formula for syntax errors, and displays an error

message if the formula is not correct.

Fig. II.28 Form for setting the display modes

Fig. II.29 Formula input form

Fig. II.30 Formula input form

The ND 287 checks whether all required operators

(e.g. 3X1 must be entered as 3*X1) have been entered,

and whether opening parentheses are followed by
closing parentheses

.

Axis values that are used as divisors may cause a
division-by-zero

or display-overflow problem. The

ND 287 prevents these errors by displaying the Display
overflow

message. After you have removed the

affected axis from the range about zero, the ND 287 will

display a correct numerical value again.

The ND 287 cannot check whether the entered formula

is going to produce a meaningful result for you. It is

your responsibility to check this.

This manual is related to the following products: