Description of key commands, Ii – 5 d ata int e rf ace – HEIDENHAIN ND 287 User Manual User Manual
Page 107

ND 287
107
II – 5 D
ata int
e
rf
ace
Description of key commands
The ND supports the XON-XOFF protocol when executing commands:
As soon as the internal character buffer is full (100 characters), the
ND sends the control character XOFF to the transmitter.
After the buffer has been executed, the ND sends the control
character XON to the transmitter and is then ready to receive data
again.
Sequence of commands
Function
Output of device identification
Output of position display value
Output of actual position
Output of error message
Output of software ID number
Output of status bar
Output of status indicators
Sequence of commands
Function
Toggle REF function
Start measurement series / SPC
Sequence of commands
Function
Reset position display
Lock keypad
Release keypad