Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 89)

3. Configure the settings for the network as follows:
For media (iSCSI) network Setting...
Ethernet is required Type
StorageNetworking is required Usage
None is required for a basic (non-redundant) K2 SAN Redundancy
Primary is required for a redundant K2 SAN media network A
Secondary is required for a redundant K2 SAN media network B
iSCSI (non-Redundant) is recommended for a basic (non-redundant) K2
SAN Name
iSCSI (Primary Redundant) is recommended for a redundant K2 SAN
media network A
iSCSI (Secondary Redundant) is recommended for a redundant K2 SAN
media network B
Selected is required Exclude from Host
Files
Selected is required Managed
The first (lowest) IP address in the range of IP addresses managed by
SiteConfig. Required. Base IP Address
The number of IP addresses in the range managed by SiteConfig.
Required. Number of Addresses
The network's subnet mask. Required. Subnet Mask
Not allowed Gateway IP Address
Unselected is required. Related settings are disabled. Unmanaged
Not allowed DNS Servers
Not allowed Default Interface
Name Suffix
4. Click OK to save settings and close.
About IP configuration of network interfaces on devices
You can perform IP configuration of network interfaces when working with a placeholder device
prior to discovery. When you add a device and choose a particular model, the model defines the
number, type and usage characteristics of network interfaces to expect on such a device.
You can view and edit each network interface and set up IP configuration selecting an appropriate
IP from the network to which each interface connects. The process for editing IP configuration
varies, depending on the device's phase.
18 November 2010 K2 SAN Installation and Service Manual 89
Planning and implementing a K2 SAN with SiteConfig