Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 135)

Configure Network Configuration page - Basic K2 SAN
This page displays the control network Ethernet port, and allows you to configure the FTP/Streaming
network Ethernet port.
NOTE: This page does not configure the iSCSI interface (media network) ports.
1. Verify that the top port is configured correctly.
The top port is the port over which the K2Config application is communicating. If correctly
configured, it is already assigned the control network IP address, as displayed on this page.
2. If the server has the role of FTP server, verify that the other port is configured correctly. If not
configured correctly, do the following:
a) Select the other port and click Modify .
A network configuration dialog box opens.
b) Enter the FTP/Streaming IP address and the subnet mask and click Apply .
For systems with an optional NH (FTP) server, the server you are now configuring does not take
the role of FTP server, so configuring the second port here for the FTP/streaming network is not
required.
3. Click Next .
The File System Server Configuration page opens.
18 November 2010 K2 SAN Installation and Service Manual 135
Configuring and licensing the K2 SAN