Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 205)

• The restart of the K2 Media Server after it is configured is complete
This task is required for NAS server functionality.
1. Verify that the K2 Media Server has restarted by opening the MS-DOS command prompt and
use the “ping” command.
2. In the K2Config application tree view, under the K2 Media Server select the File System Server
node.
The File System Server Configuration page appears.
3. Click Check and verify that the V: drive is shared.
The K2 Nearline SAN configuration is complete.
Configuring the redundant nearline K2 SAN
Work through the topics in this section sequentially to configure a redundant nearline (Tier 3) K2
SAN.
Related Links
Prerequisites for initial configuration - Nearline K2 SAN on page 205
Defining a new K2 SAN on page 128
Configuring NH server A - Part 1 on page 210
Configuring RAID on page 136
Configuring NH server A - Part 2 on page 221
Configuring NH server B on page 223
Prerequisites for initial configuration - Nearline K2 SAN
Before beginning your initial configuration, make sure the devices of the K2 SAN meet the following
prerequisites.
Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
18 November 2010 K2 SAN Installation and Service Manual 205
Configuring and licensing the K2 SAN