Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 78)

4. Work through the wizard pages, clicking Next and Finish .
If the PC does not have the appropriate version of Microsoft .NET, the SiteConfig installation
programs installs it.
5. Open the Windows operating system Services control panel on your Control Point PC and look
for an entry called " ProductFrame Discovery Agent".
The Discovery Agent must be installed on the control point PC so that the control point PC can
be discovered by SiteConfig and added to the system description as a managed device. This is
necessary to ensure name resolution in SiteConfig's hosts file.
The Discovery Agent is also known as the Network Configuration Connect Kit. For example,
in Windows Add/Remove Programs, it can be displayed as either Network Configuration Connect
Kit or SiteConfig Discovery Agent.
6. Proceed as follows:
• If the Discovery Agent is not installed, navigate to the SiteConfig install location's Discovery
Agent Setup subdirectory and double-click the
DiscoveryAgentServiceSetup.msi file. This
launches the setup program and installs the Discovery Agent. Follow the setup wizard to
complete installation. A restart is required after installation. Then continue with the next step
in this procedure.
• If the Discovery Agent is already installed, continue with the next step in this procedure.
7. If not already configured, configure the control point PC with a valid Ethernet IP address for the
LAN using Windows Network Connections.
8. If you are not going to be using SiteConfig to manage system hosts files, put the system hosts
file on the control point PC.
78 K2 SAN Installation and Service Manual 18 November 2010
Setting up the K2 SAN infrastructure