Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 123)

Restoring network configuration on page 289
Restoring from a recovery disk image CD set
The following procedure can be used on a K2 Media Server that needs all three partitions on the
system drive restored.
This procedure assumes that the image on the CD set is the system-specific image, for the particular
machine that you are restoring.
NOTE: At any step in this procedure if a message appears asking for disc/volume, insert CDs as
prompted until you can proceed to the next step.
1. Make sure that media access is stopped and that the K2 Media Server on which you are working
is not being used.
2. If you have not already done so, connect keyboard, monitor, and mouse to the K2 Media Server.
3. Insert the Recovery CD and restart the machine. If there is a problem restarting, hold the standby
button down for five seconds to force a hard shutdown. Then press the standby button again to
startup.
The machine boots from the disc. The Acronis startup screen appears.
4. At the startup screen, select True Image Server (Full Version) .
The Acronis True Image program loads.
The Acronis True Image main window appears.
5. Insert the last CD (volume) in your recovery disk image CD set. For example, if there are three
CDs that make up the disk image, insert the third CD.
6. In the Acronis True Image main window, click Recovery .
The Restore Data Wizard opens.
7. On the Welcome page, click Next .
The Archive Selection page opens.
8. In the tree view expand the node for the CD ROM drive and select the image file, then click
Next :
The Restoration Type Selection page opens.
9. Select Restore disks or partitions and then click Next .
The Partition or Disk to Restore page opens.
10. Select Disk 1 . This selects all three partitions to be restored.
If you do not want to restore all three partitions, refer to similar steps the procedure to restore
from a system-specific recovery disk image.
Click Next .
The Restored Partition Sizing page opens.
11. Select No, I don’t want to resize source partitions and then click Next .
The Restored Hard Disk Drive Location page opens.
12. Select Disk 1 and then click Next .
The Non-Empty Destination Hard Disk Drive page opens.
18 November 2010 K2 SAN Installation and Service Manual 123
Managing K2 Software