Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 351)

19. Click Save Watch to save settings and close.
The new Watch folder is added to the Carbon Admin UI. Make sure that the check box for "Active"
column is selected.
Creating the export watch folder
1. In AppCenter, create bin “K2-Coder-Export”.
2. Run Carbon Coder Admin.
3. Select Watch Folder tab.
4. Select General Properties on the left pane.
5. Enter ExportWatchFolderTemplate as the name for the Watch Folder.
The name is for display purposes only.
6. Set the Watch Folder location to V:\K2Coder\FilesFromK2 .
7. Select Create New File if the target file exists.
8. Expand Remote Retrieve and then FTP Retrieve on the left pane, then click Add... .
9. On the right pane, click the Edit button.
10. In the ServerConfig window that pops up, enter localhost for FTP Server Address, enter movie
as username, 21 for FTP server port, leave Password and Use Passive FTP empty.
11. Click Connect button.
The ServerConfig windows close automatically.
In the Watch Folder setup window, the Server Status should show “Connected to XXX”.
12. Expand the Current Folder drop down list, select bin K2-Coder-Export then click the Select button.
The Selected Folder should show “V:\GXF\K2-Coder-Export\”.
13. Enter “*” for Wildcard.
14. Enter 15 for Watch Interval (sec).
15. Click the Update button.
16. Select Target File on the left pane, then click Add... .
17. On the right pane, select system in the tree view, then select a preset such as AVI Target .
18. Set the Target Folder to V:\K2Coder\DestFiles .
19. Click the Update button.
20. Click Save Watch to save settings and close.
The new Watch Folder is added to the Carbon Admin UI. Make sure the check box for "Active"
column is selected.
18 November 2010 K2 SAN Installation and Service Manual 351
Working with the K2 Coder