Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 152)

Configuring server A - Part 2 on page 169
Configuring server B on page 173
Configuring optional NH servers on page 146
Prerequisites for initial configuration - Redundant K2 SAN
Before beginning your initial configuration, make sure the devices of the K2 SAN meet the following
prerequisites.
Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
• VLANs set up
• Trunks set up
• Power on
K2 Media Server
• Ethernet cables connected
• Fibre Channel cable connected
• Redundant servers connected by serial cable
• Software installed, as from the factory, including QuickTime 7
• Control network IP address assigned
• Power on for all servers
K2 RAID chassis
• Fibre Channel cable(s) connected
• Ethernet cable(s) connected
• Power on
K2 RAID Expansion chassis (optional)
• Fibre channel cable(s) connected
• Power on
Defining a new K2 SAN
If you import a SiteConfig system description file, you do not need to define a new K2 SAN. You
can skip this task and instead start by configuring the first K2 Media Server.
152 K2 SAN Installation and Service Manual 18 November 2010
Configuring and licensing the K2 SAN