Grass Valley K2 Summit Storage Area Network Installation User Manual

Page 122

17. Leave settings at their defaults. The size reported in the upper pane is the size detected of the

actual D: partition. This should be the same as that reported in the Partition size field in the
middle of the page. Free space before and Free space after should both be reported at 0 bytes.
Click

Next

The Next Selection page opens.

18. Select

No, I do not

and then click

Next

The Restore Operation option page opens.

19. Do not make any selections. Click

Next

The “…ready to proceed…” page opens.

20. Verify that you are restoring the correct partition or partitions. Click

Proceed

The Operation Progress page opens and displays progress.

21. When a “The data was successfully restored” message appears, click

22. Click

Operations | Exit

to exit the Acronis True Image program.

The K2 Media Server restarts automatically.

23. Remove any CD currently in the CD drive while the K2 Media Server is shutting down.

Upon restart New Hardware wizards can open.

24. Install the Fibre Channel card driver.

25. Restart the K2 Media Server.

26. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup as follows:

a) Enter in Windows Product Key and click

Next

The Product Key is on a sticker on the top of the machine near the front right corner.

b) Enter the name of the machine.

For a K2 Media Server name, enter the Serial Number (located at right side and rear).

The password is pre-set to the factory default. Leave the password as is.

c) Click

Next

d) Set Time and click

Next

Windows loads network components and restarts the K2 Media Server.

Upon restart, a Found New Hardware wizard and/or messages about services/drivers can be
displayed.

27. Restore network configuration.

28. Install K2 Media Server software. Also install related software, such as SNFS or the SiteConfig

Discovery Agent, if required for the latest upgrade. Refer to your latest K2 Release Notes for
detailed instructions.

29. You must active the Windows operating system within 30 days.

The K2 Media Server is now restored to its factory-default state. However, you can complete its
configuration as part of a K2 SAN by using the K2 System Configuration application.

on page 295

Activating the Windows operating system

on page 124

122

K2 SAN Installation and Service Manual

18 November 2010

Managing K2 Software