Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 291)

4. Reconcile the locations assigned to the adapter names with the names as currently configured in
the Name column.
The required mapping of names to locations is specified in the following table:
Must be named as follows: The adapter name (as displayed in the Device
Name column) that is assigned to this location…
Control Connection PCI bus 1, device 0, function 0
FTP Connection PCI bus 1, device 0, function 1
DO NOT USE PCI bus 2, device 0, function 0
DO NOT USE PCI bus 2, device 0, function 1
5. Proceed as follows:
• If all the names on this system are configured correctly to locations, skip the rest this procedure.
• If names on this system are not configured correctly to locations, for each adapter name
incorrectly configured, complete the remaining steps of this procedure.
6. Select the name in the Name column.
7. Select File | Rename to enter rename mode.
8. Type the name required for the location.
Next, reorder adapters.
Reorder adapters
Before doing this task, adapters must be named correctly according to their PCI bus location.
1. If not already open, open Network Connections as follows:
a) From the Windows taskbar, click Start | Network .
The Network window opens.
b) Click Network and Sharing Center .
Network and Sharing Center opens.
c) Click Change Adapter Settings .
Network Connections opens.
2. Select Advanced , then Advanced Settings…
3. On the Adapters and Bindings tab, order adapters as follows:
Control Connection
FTP Connection
DO NOT USE
DO NOT USE
4. Click OK to close and accept the changes.
5. Close Network Connections.
18 November 2010 K2 SAN Installation and Service Manual 291
Administering and maintaining the K2 SAN