Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 289)

4. In K2Config, remove all iSCSI clients from the K2 SAN. To do this, select each iSCSI client
and click Remove .
5. Use SiteConfig to change the IP address. Make sure that the IP address is within the range
designated for the network.
6. Restart the K2 Media Server.
7. In the K2Config tree view, expand the node for the media server that has the iSCSI interface
adapter for which you need to change the IP address and click the iSCSI Bridge node. The iSCSI
Bridge Server configuration page opens.
8. In K2Config, identify the iSCSI adapter for which you are changing the IP address. Since you
changed it in SiteConfig, K2Config should now display the new IP address.
9. In K2Config, add each iSCSI client again and reconfigure. Make sure you add them in the correct
order (highest bandwidth first) and enter the same bandwidth values (load balancing) for each
client as the values originally configured.
10. Place the devices of the K2 SAN back online.
Restoring network configuration
When you restore a K2 system from its system specific image, network configuration is also restored
to the factory default settings. This is the recommended method of restoring network configuration.
However, if for some other reason you must configure network settings manually, use the tasks in
this section to restore the default network configuration.
Related Links
Identify adapters on page 289
Name adapters on page 290
Reorder adapters on page 291
Set power management settings on page 292
Identify adapters
On some systems, it is possible that the Microsoft Windows operating system has enumerated
network adapter names in an unpredictable sequence. You must identify adapters by their location
rather than by the enumeration assigned by the Windows operating system and verify or modify the
adapter name as necessary.
1. If not already open, open Network Connections as follows:
a) From the Windows taskbar, click Start | Network .
The Network window opens.
b) Click Network and Sharing Center .
Network and Sharing Center opens.
c) Click Change Adapter Settings .
Network Connections opens.
2. Verify that there are four similarly named adapters listed, with the first adapter having no
enumerator at the end its name and the other adapters enumerated #2, #3, and #4 .
18 November 2010 K2 SAN Installation and Service Manual 289
Administering and maintaining the K2 SAN