Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 119)

1. Make sure that media access is stopped and that the K2 Media Server on which you are working
is out of service.
2. If you have not already done so, connect keyboard, monitor, and mouse to the K2 Media Server.
3. Insert the Recovery CD and restart the machine. If there is a problem restarting, hold the standby
button down for five seconds to force a hard shutdown. Then press the standby button again to
startup.
The machine boots from the disc. The Acronis True Image program loads.
4. At the startup screen, select True Image Server (Full Version) .
The Acronis True Image program loads.
The Acronis True Image main window appears.
5. In the Acronis True Image main window, click Recovery .
The Restore Data Wizard opens.
6. On the Welcome page, click Next .
The Archive Selection page opens.
7. In the tree view expand the node for the E: partition and select the image file, then click Next :
The Verify Archive Before the Restoring page opens.
8. Leave the selection at No, I don’t want to verify and then click Next .
The Partition or Disk to Restore page opens.
9. Select System (C:) and then click Next .
The Restored Partition Location page opens.
10. Select System (C:) and then click Next .
The Restored Partition Type page opens.
11. Leave the selection at Active and then click Next .
The Restored Partition Size page opens.
12. Leave settings at their defaults. The size reported in the upper pane is the size detected of the
actual C: partition. This should be the same as that reported in the Partition size field in the
middle of the page. Free space before and Free space after should both be reported at 0 bytes.
Click
Next .
The Next Selection page opens.
13. Depending on the partitions you are restoring, do one of the following:
• If you are restoring only the C: partition, select No, I do not and then click Next .
The “…ready to proceed…” page opens.
Skip ahead to step 20.
• If you are also restoring the D: partition, select Yes, I want to restore another partition or hard
disk drive and then click Next .
The Partition or Disk to Restore page opens. Continue with the next step in this procedure.
18 November 2010 K2 SAN Installation and Service Manual 119
Managing K2 Software