Grass Valley K2 Summit Storage Area Network Installation - Manual (Page 103)

The networks listed in the Edit IP Address dialog box are those currently defined in the system
description, with available settings restricted according to the network definition. If you
require settings that are not available, you can close dialog boxes and go to the
Network
Configuration | Networks tab to modify network settings, then return to the Edit IP Address
dialog box to continue.
9. When you have verified that the planned settings are correct, click OK , then Yes to apply settings
to the device and close.
A Contacting Device message box reports progress.
10. After configuring control network settings, do the following
a) If a message informs you of a possible loss of communication, click OK .
This message is normal, since this is the network over which you are currently communicating.
b) In the Device list view, observe the device icon and wait until the icon displays the green star
overlay before proceeding.
The icon might not display the green star overlay for several seconds as settings are
reconfigured and communication is re-established.
c) In the Interface list view, right-click the interface and select Ping .
The Ping Host dialog box opens.
If ping status reports success, the interface is communicating on the control network.
NOTE: For the K2 Summit Production Client, when configuration is complete, make sure
you lock the device in SiteConfig. This enables the write filter.
Modifying K2 Media Server managed network interfaces
Prerequisites for this task are as follows:
• The physical device you are configuring has been discovered and is assigned to a device in the
SiteConfig system description.
• SiteConfig has communication with the device.
• The device is defined in the system description with an appropriate network interface.
Use this task to modify managed network interfaces on a K2 SAN device as follows:
• 10G K2 Media Server
• NH K2 Media Server
18 November 2010 K2 SAN Installation and Service Manual 103
Planning and implementing a K2 SAN with SiteConfig