Grass Valley K2 System Guide v.7.2 - Manual (Page 71)

07 April 2010 K2 System Guide 71
Installing Pathfire Transfer Service software
To install Pathfire software, you must run multiple installation programs, as directed
by the following procedures:
Install first DMG Master software
1. If installing on a K2 Summit Production Client or K2 Solo Media Server, disable
the write filter.
2. If you have any files in C:\temp that you want to save, copy the files to a different
location.
3. Make the contents of the Pathfire Transfer Service CD-ROM accessible to the K2
system.
4. Open DMGMASTER40IT79.exe. The name of this file might change slightly,
depending on the version of Pathfire Transfer Service software.
InstallShield Wizard opens and extracts files for two sets of data. The entire
extracting process is less than 3 minutes. When the process completes, the Pathfire
Digital Media Gateway Installation program opens and runs.
5. When the Welcome to the InstallShield Wizard for DMG window displays, click
Next to progress through the wizard.
6. When you arrive at the License Agreement window, click Yes .
7. In the Installation Type window, select Station Integration (3xx, 6xx) and then click
Next .
8. In the Enter Text window, enter the IP address of the Pathfire DMG Receive Server
from which you are pulling content as input for the K2 Pathfire capture service.
If an IP address is already entered, it is the IP address of the server as detected from
a previous install.
9. Once the IP address of the Pathfire DMG Receive Server is correctly entered, click
Next .
A series of message boxes display for approximately twelve minutes as the
necessary “skins” are installed. Once completed, the DMG Install Complete dialog
box displays.
10.In the DMG Install Complete dialog box, respond as appropriate to restart and
allow the K2 system to restart.
11.Continue with the next procedure “Install second DMG Master software” .
Install second DMG Master software
Prerequisites for this procedure are as follows:
• The first DMG Master software is installed on the K2 system.
1. If installing on a K2 Summit Production Client or K2 Solo Media Server, disable
the write filter.
2. If you have any files in C:\temp that you want to save and you have not already
done so, copy the files to a different location.
3. If you have not already done so, make the contents of the Pathfire Transfer Service
CD-ROM accessible to the K2 system.