Grass Valley K2 System Guide v.7.2 - Manual (Page 123)

07 April 2010 K2 System Guide 123
Placing the K2 system into online mode
5. Repeat this procedure on each drive.
6. When finished, exit Storage Utility.
7. Put AppCenter channels back online.
8. Restart.
Placing the K2 system into online mode
If the stand-alone K2 system is in offline mode and you have completed your storage
system configuration tasks, you have the following options to return the system to the
online mode:
• Exit Storage Utility and bring channels online — If Storage Utility is closed, first
open Storage Utility and then exit Storage Utility. When you exit Storage Utility
you are prompted “…back to online mode?'. Click
Yes .
After exiting Storage Utility, if AppCenter is open the channels remain offline. To
bring channels online, if you are running AppCenter on a Control Point PC, select
System | Reconnect . If you are running AppCenter on a local K2 system, close and
reopen AppCenter.
• Restart the K2 system — Restarting automatically resets the system to online mode.
When you log into AppCenter channels connect and come up online.