Grass Valley K2 System Guide v.7.2 - Manual (Page 175)

07 April 2010 K2 System Guide 175
Setting up direct-connect RAID storage
Connect K2 client Fibre Channel ports to RAID controllers. Connect Fibre
Channel port 1 to RAID controller 0. If you have the redundant controller,
connect Fibre Channel port 2 to RAID controller 1.
Connect RAID controller LAN ports to control ports on a K2 GigE switch. If
you have redundant switches, connect controller 0 to switch A and controller 1
to switch B.
Connect RAID controller DP0 ports to the first Expansion chassis DP-IN ports.
Connect remaining Expansion chassis using DP-OUT and DP-IN ports.
2. Connect power cables and power up the RAID devices. Refer to “Powering up K2
RAID” later in this chapter.
3. Connect remaining cables to the K2 client. Refer to the Quick Start Guide for the
particular K2 client model for cabling details.
4. Start up the K2 client.
The Windows initialization screen shows the progress bar but does not complete.
5. Power down the K2 client.
6. Disconnect all Fibre Channel cables from the K2 client.
BBU IN MODEM
FLT/LNK
HPE FLT
A/L
BACKUP
ACT/LNK
LNK/ACT
FLT
HP
5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP 1 0
BBU IN MODEM
FLT/LNK
HPE FLT
A/L
BACKUP
ACT/LNK
LNK/ACT
FLT
HP
5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP 1 0
Controller 1 Controller 0
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
DP0 DP0
To control port
on GigE switch To control port
on GigE switch
To K2 client
Fibre Channel port To K2 client
Fibre Channel port
RAID Primary
RAID Expansion 1
RAID Expansion 2
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
RAID Expansion 3
Cable connectors are keyed
to DP IN/OUT ports.