Grass Valley K2 System Guide v.7.2 - Manual (Page 154)

154 K2 System Guide 07 April 2010
Chapter 6 Managing K2 system software
Installing K2 software
Except as noted in the preceding sections, when you receive your K2 system, you do
not need to install software. The system has software pre-installed at the factory.
If you are upgrading software on a K2 system, refer to the K2 Release Notes for that
version of software for specific upgrade procedures. If you are upgrading a K2 SAN,
you must use SiteConfig with the proper sequence and upgrade all K2 Media Servers
and K2 clients to the same software version. Upgrade K2 Media Servers first, then K2
clients. Refer to K2 Release Notes for the complete explanation of the rules that apply
to upgrading software on the K2 SAN.
Before upgrading K2 software, you should make a recovery image.
Pre-installed software
Software is pre-installed on K2 products when you receive them from the factory.
Refer to K2 Release Notes for version updates.
Backup and recovery strategies
Find information on creating images, restoring from images, and other backup and
recovery information as follows:
For this device… Find information in this documentation:
K2 Summit Production Client K2 Summit Production Client Service Manual
K2 Media Client K2 Media Client Service Manual
K2 Solo Media Server K2 Solo Media Server Service Manual
K2 Media Server K2 SAN Installation and Service Manual
Control Point PC Use procedures from a K2 client Service Manual