Grass Valley K2 System Guide v.7.2 - Manual (Page 185)

07 April 2010 K2 System Guide 185
Using BVW protocol to control K2 systems
Using BVW protocol to control K2 systems
BVW commands are available via RS-422 serial ports.
A subset of BVW commands is supported through AppCenter in protocol mode.
Insert/Edit is not supported.
In AppCenter, you must set a channel’s options to enable protocol control of the
channel. Subsequently, when the K2 client starts up, the channel is immediately
available for protocol control. Manual log on is not required.
For channels in gang mode, the protocol must connect to the lowest numbered channel
in the gang. This is required to support jog/shuttle of ganged channels.
To set in and out points with BVW protocol, load clips only from the working bin.