Grass Valley K2 System Guide v.7.2 - Manual (Page 103)

07 April 2010 K2 System Guide 103
Install and configure Macintosh Final Cut Pro systems on K2 storage
ls –le
e. Verify that there is a "+" next the text file, plus a list of permissions below. If
this is true then cross-platform ACLs are enabled.
f. Open the Finder, go to the default volume and try to edit the text file. This
should fail as the file should not be writeable.
g. In the Finder, go to the folder you created earlier in this procedure and create a
text file in the folder. This operation should be successful.
h. Log out and then log back in as userB.
i. In the Finder, go to the folder you created earlier in this procedure and try to
create a text file in the folder. This operation should fail.
Configure HotBin
If a K2 SAN, the SNFS configuration file must have settings as follows:
• If Windows Security is No, GlobalSuperUser must be set to Yes.
• If Windows Security is Yes, no GlobalSuperUser setting is required.
Configure a HotBin on the K2 system to receive the finished media from Final Cut
Pro.
1. In K2 AppCenter, create a bin with an appropriate name, such as "dstBin".
2. Configure dstBin as a HotBin.
Refer to the K2 System Guide for instructions.
3. When you configure a HotBin, in the Capture Services Utility you can adjust
QuickTime Import Delay. The recommended setting is 15 seconds. Refer to the