Grass Valley K2 System Guide v.7.2 - Manual (Page 244)

244 K2 System Guide 07 April 2010
Appendix D Rack mounting
Installing the K2 system on the rack mount rails
To install the K2 system on the rack mount rails:
1. Pull the slide-out track section to the fully extended position.
WARNING: To prevent injury, two people are required to lift the K2
system. It is too heavy for one person to install in the rack.
WARNING: To prevent serious injury, ensure that the rack is anchored
to the floor so that it cannot tip over when the K2 system is extended out
of the rack.
NUT BAR
(Use if the front rail is not tapped)
FRONT RACK RAIL
Because the system is 1 RU,
the two front screws must
align with the mounting
holes as shown.
REAR RACK RAIL
Locking
bracket
(Nut bar not visible)
!
!