Grass Valley K2 System Guide v.7.2 - Manual (Page 134)

134 K2 System Guide 07 April 2010
Chapter 5 Managing stand-alone K2 systems with SiteConfig
4. Click OK to save settings and close.
Adding a group
1. In the Network Configuration | Networks tree view, right-click a site node and select
Add Group .
The group appears in the tree view.
2. Right-click the group and select Rename .
3. Enter the desired name for the group.
Adding stand-alone K2 clients to the system
description
Prerequisites for this task are as follows:
• The system description contains a group.
1. In the Network Configuration | Devices tree view, right-click a group and select Add
Device .
Setting... For FTP/streaming network
Type Ethernet is required
Usage FileTransfer is required
Redundancy None is required. This is true even on a redundant K2 SAN. (Only the iSCSI
network is redundant on a redundant K2 SAN.)
Name Streaming is recommended
Exclude from Host
Files Unselected is required
Managed Selected is required
Base IP Address The first (lowest) IP address in the range of IP addresses managed by
SiteConfig. Required.
Number of Addresses The number of IP addresses in the range managed by SiteConfig. Required.
Subnet Mask The network's subnet mask. Required.
Gateway IP Address Additional network settings managed by SiteConfig. Allowed.
Unmanaged Unselected is required. Related settings are disabled.
DNS Servers Servers providing DNS for name resolution. Allowed.
Default Interface
Name Suffix _he0 is required