Grass Valley K2 System Guide v.7.2 - Manual (Page 144)

144 K2 System Guide 07 April 2010
Chapter 5 Managing stand-alone K2 systems with SiteConfig
14.As in steps earlier in this procedure, reconcile planned and current settings. If you
must edit the IP address, make settings as follows:
15.When you have verified that the planned settings are correct, click OK , then Yes to
apply settings to the device and close.
A Contacting Device message box reports progress.
For the K2 Summit Production Client, when configuration is complete, make sure
you lock the device in SiteConfig. This enables the write filter.
Adding a control point PC placeholder device to
the system description
Prerequisites for this task are as follows:
• The system description contains a group.
1. In the Network Configuration | Devices tree view, right-click a group and select Add
Device .
The Add Device dialog box opens.
2. Configure settings for the device you are adding as follows:
• Family – Select System Management .
• Type – Select ControlPoint PC .
Setting... For network interface Media Connection#1
Network Streaming is required
Address Allocation Static is required.
IP Address The IP address for this interface on the network. Required.