Grass Valley K2 System Guide v.7.2 - Manual (Page 34)

34 K2 System Guide 07 April 2010
Chapter 2 Using K2 system tools
To save custom settings:
1. In the Configuration Manager, click the Save button.
The Save As dialog opens.
2. Use the up arrow or select folders to navigate to the folder in which you want to
save the configuration file.
3. Enter a name for the configuration file.
Do not name the file DefaultConfig.xml, as this name is reserved for the factory
default configuration file. Otherwise, standard Windows 2000 and up file naming
restrictions apply.
4. Click Save and Close .
To restore custom settings:
1. If you want to save current settings, you should save them as a configuration file
before continuing.
2. In the Configuration Manager, click the Load button.
The Open dialog opens.
3. Use the up arrow or select folders to navigate to the custom configuration file.
4. Select the custom configuration file.
5. Click Open .
The custom settings are loaded into Configuration Manager, but they have not been
saved and put into effect.
6. Click OK to save and apply settings, and to close the Configuration Manager.
Restoring default Configuration Manager settings
You can restore factory default settings as follows:
• Restore some individual settings or groups of settings by selecting the Default
button which appears below the settings in the configuration screen.
• Restore all the settings in Configuration Manager at once to their default values as
explained in the following procedure.
To restore all settings at once to their default values:
1. If you want to save current settings you should work through the previous
procedure “Saving and restoring Configuration Manager settings” before
proceeding.
2. In the Configuration Manager dialog, click Restore .
The default settings are loaded into Configuration Manager, but they have not yet
been saved and put into effect.
3. Click OK to save settings and close Configuration Manager.