Grass Valley iTX System v.2.6 - Manual (Page 45)

Installing iTX software modules
About the main iTX Installer dialog
After you select a software module in the Select Software To Install dialog, the installer displays
the iTX Installer dialog, showing the components in the module:
It sorts the components into two lists: an action list in the upper half of the dialog; a no-action
list in the lower half.
The action list contains components that the installer is going to take specified action on; the
no-action list, components that it is not going to take any action on.
You may use the Action and No Action buttons to move selected components from one list to
the other.
The first time you run the installer on a particular machine, all software components in selected
modules are selected for installation. They appear in the action list; the no-action list is empty.
Note:
• We recommend you accept the default selection for the first installation of a software
module.
Running the iTX installer to upgrade or modify an installation
When you re-run the iTX installer after installing any iTX software module, the iTX Installer
dialog appears (instead of the Select Software To Install dialog). The dialog displays details of
installed components; these appear in the no-action list if the installed versions match those in
the installation folder; or in the action list (together with any new components requiring
installation) if the installation folder contains later versions.
You may use the buttons at the bottom of the dialog when upgrading software, changing the
usage of a machine or re-configuring a machine for a different System Database:
March 2015 System Administrator Guide Page 45 of 404