Grass Valley iTX System v.2.6 User Manual
Page 188
Configuring channel plug-ins
3.
To adjust the logo transparency, click Options to display the Logo Options dialog. Adjust
the Key Level slider.
You may set vision effects for the logo in the Logo Options dialog, before clicking OK to
close the dialog. Or, you may set them in the configuration panel (as described below).
4.
Click OK first to close the Logo Editor; then again to close the Live Logo Setup dialog.
You may click Save to save your changes at this stage.
5.
In the configuration panel, do one of the following to assign a logo type and set the timing.
•
Click Permanent if you want iTX to permanently display the logo, starting at an offset
from the start of an associated primary event. In the Offset box, enter the value of the
offset.
•
Click Clip Dur if you want iTX to display the logo while a primary event plays; the logo
switches on at an offset from the start of the primary event and switches off at an equal
offset from the end. In the Offset box, enter the value of the offset.
•
Click Plus if you want iTX to display the logo for a specified duration, starting at an offset
from the start of a primary event. In the Offset box, enter the value of the offset; in the
Dur box, enter a value for the duration.
•
Click Minus if you want iTX to display the logo for a specified duration, starting at an
offset from the end of a primary event. In the Offset box, enter the value of the offset;
in the Dur box, enter a value for the duration.
6.
Click In, to select the in-point settings:
Then do one of the following to set the vision effect for the logo in-point.
•
Click a transition-type selection button, for a cut or cross-fade transition.
•
Click Wipe, Slide or Squeeze to select a type of effect; click one of the arrow buttons to
select the direction; enter a value in the In box to set the duration of the effect.
7.
Click Out, to select the out-point settings. Repeat the previous step (but specify a duration
in the Out box for any effect you select) to set the vision effect for the logo out-point.
8.
Click Save.
iTX updates the logo properties.
March 2015
System Administrator Guide
Page 188 of 404