Enter crosspoint details in the system database, Perform test routes, Install the nvision nv9000 router service – Grass Valley iTX System v.2.6 User Manual
Page 322
Using iTX with a matrix router
Enter crosspoint details in the System Database
1.
Select the GVG Acappella Router Server window.
2.
Select the Matrix tab.
3.
Check the service displays lists of the sources and destinations that are on the GVG
Acappella router.
4.
On the Routing Configuration pop-up layout, use the Routing Configuration Tool to enter
Perform test routes
On the Routing Configuration pop-up layout, use the Routing Configuration Tool to make test
routes.
Installing an NVision NV9000 Router Control System Service
To enable iTX to operate an NVision NV9000 router, you install the NVision NV9000 Router
Service component (from the Routers module). The NVision NV9000 Router Control System
Service in this component can control one NVision NV9000 router. We recommend you install
the component on the Database Server machine.
Install the NVision NV9000 Router Service
1.
Double-click Setup.exe in the installation folder, iTX Suite, to start the installer.
The installer displays the iTX Installer dialog.
2.
Click Select Software to open the Select Software to Install dialog.
3.
Expand the Routing category and then the Routers sub-category.
Select the NVision NV9000 Router Service component; select the Server Base if you are
installing the component on a machine that does not already have a Server Controller
installed. Ensure the other components in the Routers module are not selected.
Click OK to close the Select Software to Install dialog.
4.
The iTX Installer dialog shows the components that you selected.
5.
Click Continue.
The installer performs the installation. In doing so, it places a configuration file in a folder
with the program executable. The default path of the folder is:
C:\Program Files (x86)\iTX 2.0\Services\NV9000RoutingService
The program configuration file is called "G3NV9000RouterService.exe.config".
6.
When the installer completes the installation, click Finish to close the iTX Installer dialog.
March 2015
System Administrator Guide
Page 322 of 404