Grass Valley iTX System v.2.6 - Manual (Page 323)

Using iTX with a matrix router
Running the NVision NV9000 Router Service
The Server Controller on the same machine automatically starts the NVision NV9000 Router
Control System Service. When the router-control service starts for the first time, it registers the
details of the router in the System Database.
Configuring an iTX system after the installation of an NVision NV9000
Router Control System Service
You need to configure the router-control service to work with the NVision NV9000 router. To
do this, you enter network-connection details of the NVision NV9000 router that the service is
to control.
Enter the router connection details in the program configuration file
1. Open the configuration file, "G3NV9000RouterService.exe.config".
2. Enter the IP address and port of the NVision NV9000 router by changing the values for the
"RouterIpAddress" and "RouterPort" keys in the appSettings section.
For example:
...
...
3. Save the configuration file.
Enter router connection details in the NVision NV9000 Router Control System
Service
1. Select the NVision NV9000 Router Control System Service window.
2. Select the Setup tab.
3. Do the following to set the router connection details.
• Enter the name of the NVision NV9000 router in the Name box.
• Enter the IP address in the IP Address box.
• Enter the port number in the Port box.
• In the Diagnostic Source box, enter the router source the service is to use for
diagnostics tests.
• In the Diagnostic Destination box, enter the router destination the service is to use for
diagnostics tests.
• In the Check for Connection Rate time entry box, enter how often the service should
check its connection to the NVision NV9000 router.
March 2015 System Administrator Guide Page 323 of 404