Grass Valley iTX System v.2.6 - Manual (Page 214)

Configuring the audio output for a playout channel
• Display a test report for any media file, giving details of the audio tracks in the file and
how they are to be used in the channel output.
After changing any of the configuration on the Audio Mapping panel, you need to click Save on
the same layout to save your changes.
Display the Audio Mapping panel
1. On the Engineering layout, click Channel Config to display the Channel Configuration pop-
up layout.
2. Select a channel view in the View box; select a playout channel from the Channel Selector.
3. Under the Channel tab, select the Channel Config 4 tab.
The Audio Mapping panel appears under this tab.
Add an audio track to the output of a playout channel
1. On the Audio Mapping panel, click Add.
iTX adds an entry for a new audio track in the Audio Mapping panel. You need to configure
this as described below, "Configure an output audio track".
Remove an audio track from the output of a playout channel
1. On the Audio Mapping panel, select an entry for an audio track.
2. Click Remove.
iTX removes the entry from the Audio Mapping panel.
Note: If you remove all entries from under the Media tab, you set up iTX for clip mapping. More
details , page 213.
Configure an output audio track
1. For any entry in the Audio Mapping panel, select an output type from the Audio Type
dropdown box.
2. If you want to specify track tags for iTX to search for among source audio tracks, do the
following.
•
Click the Language box to display the Language Selection dialog:
March 2015 System Administrator Guide Page 214 of 404