Uninstall components of an itx software module, Manually delete the installer configuration file – Grass Valley iTX System v.2.6 User Manual
Page 294
Upgrading or uninstalling iTX software modules on single machines
The installer marks the components for the action "Uninstall".
Uninstall components of an iTX software module
1.
Do one of the following to select the software module you want the iTX installer to
uninstall.
•
Use the iTX installer to automatically add the module components to the action list.
•
Manually select the module components and move them to the action list.
2.
Check the action list. If necessary, remove components from the list by selecting them and
clicking No Action.
3.
Click Continue.
The installer uninstalls the selected components.
After removing manually selected components (but not those selected automatically by
the installer), it leaves them in the action list; they appear marked for "Install".
Note: If you click Continue, the installer re-installs these components.
4.
Do one of the following to close the iTX Installer dialog.
•
Click the close button in the upper, right corner of the dialog.
•
Move all components into the no-action list; then click Continue.
Installing a different type of iTX software module on a machine
The installer configuration file identifies a machine as a particular type of iTX machine
(Database Server, Output Server, etc.).
There are two ways in which you can change the machine type (for example, from an Output
Server to an Encode Server):
•
You can uninstall the current module, manually delete the configuration file and then
install a new module.
•
You can replace the current module with one for a different type of machine. By doing
so, you overwrite the configuration file.
Manually delete the installer configuration file
1.
After uninstalling an iTX software module, click Delete Config in the iTX Installer dialog.
The installer deletes the configuration file. It then displays the Select Software to Install
dialog, from which you can install any iTX software module.
Replace an installed iTX software module with a module of a different type
1.
Double-click Setup.exe to start the iTX installer.
The iTX Installer dialog lists the components for the installed modules.
2.
Click Select Software.
The installer displays the Select Software to Install dialog.
March 2015
System Administrator Guide
Page 294 of 404