Grass Valley iTX System v.2.6 - Manual (Page 163)

Configuring channels
Note:
• It is not possible to have SCTE104 and Enhanced SCTE104 enabled at the same time.
The table below describes the functions of the Enhanced SCTE 104 options:
Option Description
Enhanced SCTE 104 Click to enable enhanced SCTE 104 on the output server. This
will disable SCTE 104 Signal, if already enabled.
SCTE 104 Event Mask Enter a (decimal value) to be used for event masks. This can be
used to perform partial or full replacement of
splice_event_Id Inbound SCTE messages.
The mask configuration allows for bit level “OR” masking. For
example:
• Incoming message (hex): 0x00005c7e
• Inputted Event Mask string (dec): 1073741824
• Actual Event Mask (hex): 0x40000000
• Output (hex):
0x40005c7e
SCTE 104 Output Line Enter the VANC line number on which to output SCTE
messages.
If
Pass-Through on Output Line is also enabled, incoming
messages will be passed through on this output line number.
National Breaks Enable national break commands.
Local Breaks Enable local break commands.
Pass-Through Enable Enable message pass-through.
Pass-Through on Output
Line
Enable message pass-through on the VANC line number
specified in SCTE 105 Output Line .
For example, if SCTE 104 Output Line is set to VANC line 7
for SCTE insertion, messages received on VANC line 10 will be
passed through on VANC line 7.
National/Local Breaks
March 2015 System Administrator Guide Page 163 of 404