Grass Valley iTX System v.2.6 - Manual (Page 356)

Configuring an iTX Desktop to accept commands from a keyboard or hard panel
The Assign Input dialog opens:
3. Ensure Selected Input is selected.
4. Do one of the following to set a keyboard or hard-panel operation.
• Press a key or key combination on the keyboard. The Selected Device box shows
keyboard as the device type; the Selected Input box shows the keyboard shortcut.
• Operate a control on the hard panel. The Selected Device box shows the hard panel as
the device type; the Selected Input box shows the control name.
• Click Select Input to display the Select Input dialog. This shows the layout of controls on
an installed hard panel:
Device selection buttons, in the top left of the dialog, enable you to switch between the
hard-panel layout and an on-screen keyboard.
Operate a control on the hard panel; or press a key (or key combination) on either your
workstation keyboard or the on-screen keyboard. Click OK to close the Select Input
dialog.
The Selected Device box in the Assign Input dialog shows the device type; the Selected
Input box shows the control name or keyboard shortcut.
March 2015 System Administrator Guide Page 356 of 404