Comtech EF Data CDM-600/600L - Manual (Page 87)

CDM-600/600L Open Network Satellite Modem Revision 3
Front Panel Operation MN/CDM600L.IOM
5–11
CONFIG: TX Æ POWER Æ MODE Æ AUPC Æ TARGET-EbNo-RANGE
MINIMUM EbNo OF REMOTE MODEM = 5.0dB
MAXIMUM PERMITTED POWER INCREASE = 9dB
On the top line, to edit the Target Eb/No of the remote modem, use the [ ←][→] arrow keys to
select a digit, then edit the value of that digit using the [ ↑][↓] arrow keys. The default value is 3.0
dB; the upper limit is 14.9 dB.
On the bottom line, to edit the maximum permitted increase in power level when in AUPC mode,
use the [
←][→] arrow keys to select a digit, then edit the value of that digit using the [↑][↓] arrow
keys. The default value is 1dB; the upper limit is 9 dB.
Press [ENT] when done.
CONFIG: TX
Æ POWER Æ MODE Æ AUPC Æ ALARM/ACTION
MAX TX PWR ACTION = NONE (NONE, TX-ALM)
REM DEMOD UNLOCK ACT = NOM-PWR (NOM,MAX)
On the top line, to determine the action that will occur if the AUPC causes the maximum output
power level to be reached, select None or Tx Alarm using the [
↑][↓] arrow keys.
On the bottom line, to determine the action that will occur if the remote demod is unlocked, using
the [
↑][↓] arrow keys. The choices are:
NOM-PWR (Nominal Power) The output level will revert to the nominal power level set under Manual.
MAX-PWR (Maximum Power) The output level will change to the maximum permitted.
Press [ENT] when done.